The waste of power cables in high-rise buildings and large factories is severe, increasing the risk of faults. For example, when 10000 meters of power cables with equal cross-section and busducts are required for workshop power supply, the maximum length of enclosed busducts is only 8000 to 9000 meters. Due to the high loss during cable budgeting, procurement and construction, it is difficult to keep, inventory and transportation. However, when using equal cross-section busducts for construction, it is basically zero loss, Moreover, technical personnel from busduct manufacturers will actively participate and assist on-site, optimize on-site design, and provide full technical services free of charge, greatly reducing the cost of use for users and making them worry free and effortless.

The epoxy resin vulcanized busduct produced by Mega Technology has waterproof and dust-proof ability. The busduct during power on is immersed in a fish tank, and water enters the insulation conductor room from all angles of the busduct, the busduct still functioning normally and the fish are still alive! The only type with high pressure resistance and fire resistance is that under a flame (1300 ℃) roasting for 10 seconds, the insulation layer is not damaged and the heat is dissipated in an extremely short time, without any problems with skin contact! Strong resistance to oxidation and salt spray. Sulfide coating will completely eliminate contact with air on the conductor, and after 1800 hours of salt spray testing, the insulation layer will never be damaged. It has super strong toughness and strength, and has the ability to withstand cold and hot cycling damage.